Replacing a Heating Element in a Philadelphia Water Heater

Posted by on May 20, 2014 in Water Heater Repair Philadelphia | 0 comments

If your water is not heating appropriately and you think a defective heating element follow these seven steps on screening and changing it. Bad elements are common troubles specifically in older water heaters that have actually been in a few years. This can take place to a more recent heater also. This is easily diagnosed and replace it could need a little perseverance.

Water Heater Repair Philadelphia

Note: It is best to have a trained plumbing professional perform these steps. Water Heater Repair Philadelphia just wanted to share the process for doing with our readers.

Tools needed: Ohm/Volt meter, heating element socket, [both of which can be purchased at a hardware shop], screw vehicle drivers Phillips and flat head.

Step one: Heating elements that go bad are quickly detected by first shutting off the power to the heater then removing the access covers one at a time and examining each element separately. This will likewise work on loud elements, ones that have calcium buildup. The access covers are usually on the side of the tank one on top one on the bottom. Turn supply of water off and drain the tank unless one is experienced at changing elements with a complete tank.

Step Two: After eliminating the leading access cover, get rid of the insulation that is behind it this should have been cut at the factory. The insulation will come right out. Then raise the plastic cover to expose the element. This will be on the bottom half of the cover.

Step Three: Eliminate one wire off the element and afterwards put the meter on ohms and touch both contacts to see if it reads. If it does not read the element is probably bad and requires replacing. If it reads then continue to examine the next one. In electric water heaters there is a bottom and a top element.

Step Four: After determining where the bad element is remove both wires ensuring the power is off. Put the element socket on a cog and turn the element counter clockwise removing it. Some force might have to be put into this.

Step Four: Put the Gasket on the new element and hand tighten where the old element was and turn clockwise until tight. Complete tightening the element with the cog.

Step Five: Put the wires back on ensuring they are snug.

Step 6: Fill the tank with water opening the hot water valves in the house to draw out air from the lines. Remove aerators on any faucets that are open and put them back on when finished. After the water is flowing in the sink or tub turn it off. Check for leaks after this is done.

Precaution: Do not turn the power on before the tank is complete or another element could be damaged.

Step Seven: Turn the electrical power back on put the insulation and covers back on. The hot water problem will be fixed.

Don’t hesitate to contact Water Heater Repair Philadelphia PA with any questions you may have.

Resources:

How to Repair an Electric Water Heater

Electric Water Heater Element Tests

How to Test a Water Heater Element Video

 

Enhanced by Zemanta